Breathable Casing Spray Powder Coating
General Introduction:
Breathable powder coatings are mainly functional powder coatings composed of special resins, fillers and additives, with good deqigong energy and film surface smoothness, suitable for the workpiece surface rough cast iron, cast aluminum, hot rolled plate and other products.
To use:
The powder is used in the coating of cast iron, cast aluminum, hot rolled plate and other products.
Product Series:
provide plain powder coating products suitable for indoor or outdoor use.
Also according to the user's demand to provide a variety of appearance and gloss products.
Physical Properties:
Specific gravity(g/cm3, 25℃): 1.2-1.8
Particle size distribution: adjust according to different kinds of powder and coating requirements
Curing conditions: according to the different varieties of products, please refer to the attached technical specifications of the products.
Curing Conditions:
120℃(refers to MDF plate surface temperature), 20 minutes. The oven may use the ordinary hot air circulation oven or the drying path, the condition permits the best first USES the infrared ray oven to spray the good coating to carry on the rapid heating flow leveling, then sends the ordinary oven to bake to solidify.
Coating performance:
|
Testing item |
Inspection standard or method |
Test indicators |
|
impact resistance |
ISO 6272 |
50kg.cm |
|
cupping test |
ISO 1520 |
8mm |
|
adhesive force(row lattice method) |
ISO 2409 |
0 level |
|
bending |
ISO 1519 |
2mm |
|
pencil hardness |
ASTM D3363 |
1H-2H |
|
salt spray test |
GB 1771-1991 |
>500 hours |
|
hot and humid test |
GB 1740-1989 |
>1000 hours |
|
heat resistance |
110℃X24 hours (white) |
excellent light retention, color difference≤0.3-0.4 |
Notes:
1.The above tests used 0.8mm thick cold-rolled steel plates with a coating thickness of 30-40 microns after standard pretreatment.
2.The performance index of the above coating may change with the change of gloss and artistic effect.
Average coverage:
10-12 sq.m./kg; film thickness 60 microns (calculated with 100% powder coating utilization rate)
Packing and transportation:
cartons are lined with polyethylene bags, net weight is 20kg. Non-hazardous materials can be transported in various ways, but only to avoid direct sunlight, moisture and heat, and avoid contact with chemical substances.
Storage Requirements:
Store in a ventilated, dry and clean room at 30℃, not close to the fire source, central heating and avoid direct sunlight. It is strictly prohibited to pile up in the open. Under this condition, the powder can be stored for 6 months. After the storage life can be re-examined, if the results meet the requirements, can still be used. All containers must be repackaged and repackaged after use.
Notes:
All powders are irritating to the respiratory system, so avoid inhaling powder and steam from curing. Try to avoid direct contact between skin and powder coating. Wash skin with water and soap when contact is necessary. If eye contact occurs, wash skin immediately with clean water and seek medical attention immediately. Dust layer and powder particle deposition should be avoided on the surface and dead corner. Tiny organic particles will ignite and cause explosion under static electricity. All equipment should be grounded, and construction personnel should wear anti-static shoes to keep the ground to prevent static electricity.
